Identification Cable Ties - Details

RTID Series Identification Cable Ties
One-piece injection-molded construction combines bundle identification and fastening with one tie without sacrificing holding strength, in three styles for a variety of bundling applications. A matte surface provides space for stamping or hand labeling. Use All-States fine-tipped nylon-penetrating marking pens for clear, permanent identification.

RTID Series Identification Cable Ties with standard cross-section for bundles from 3/8" to 4" diameters. The integral ID plate is inside the head, and runs perpendicular to the bundle for good visibility. Plates are ½" X 1-3/16" in the 675 model and ½" X 2-1/4" in 1100 and 1400. All have a matte writing surface on the exposed side.

RTIDE Series Identification Cable Ties have the ID plate molded outside of the head. These ties can hold smaller bundles than any other identification ties because the plate is outside the head. Miniature cross-section tie holds bundles from 1/16" to ¾". Both sides of this exterior 3/8" X 13/16" plate are matte finish for labeling ease and versatility. This tie is useful for applications requiring prominent flagging.

RTIDI Series Identification Cable Ties are available in miniature cross-section for bundle diameters from ¼" to ¾". The integral ID plate is inside the head. Because the ID plate runs parallel to the bundle, these ties can hold smaller bundles than ties with in-line plates. Plate sizes are 5/16" X 1" with the matte writing surface on the exposed side.